Mohammad from Cornerways Garage Milton Keynes was friendly but as a mechanic useless, he used his diagnostic machine to ignore and then clear the codes that were at the crux of the problem, then proceeded to tell me that maybe the wire leading to the glow plugs maybe short circuit and that I should get an electrician this guy is useless, use at your peril, also I've been driving with this glow plug code with no problem, this is the diagnostic report that I gave To Mohammad before he turned up.

Diagnostic Inspection
Patrol found the following fault code/s:System : Engine control 1 - 1Z2 / Engine management CR/EDC SID208P067100 - Engine glow plug, cylinder 1. Error Message : Malfunction.P067400 - Engine glow plug, cylinder 4. Error Message : Malfunction.P228D00 - Fuel pressure regulation. Error Message : Pressure too high.P008800 - Rail pressure sensor 1. Error Message : Malfunction.P008824 - Rail pressure sensor 1. Error Message : Signal too high.P008835 - Rail pressure sensor 1. Error Message : Signal too low Read more

Mo was very helpful and explained the issue and gave good advice on where to purchase what was needed.

Checked vehicle and advised that battery and starter motor were just fine and that the problem was rather more fundamental. Very polite and gave some well informed advice. Many thanks.