Austin ABS repair made easy

• Depending on the specific job - an ABS repair may include all or some of the following steps
• Mechanic will diagnostically inspect the ABS system.
• If necessary, the mechanic will replace the faulty ABS sensor and re-test the component.
• If the ABS module is at fault, the mechanic will advise on the best course of action in order to have it repaired.
• Mechanic will test drive and inspect the braking system.

• The car's ABS warning light stays on permanently once the engine is started.
• The brakes lock up very easily when braking on slippery surfaces.
• The brakes do not respond as well as normal under hard braking

The time an abs repair will take will depend on the type of repair needed and a number of factors, like your vehicle's make and model, year, as well as other factors. Select your car at the top of this page for information on job time and cost for your vehicle through ClickMechanic.

It is rare that an ABS control module has to be replaced as it is an electric component that normally would not need servicing. In some cases, though, it can be that the module's electrical connectors have corroded or that the electrical wires might have been damaged.

Often its ancillaries are more likely to go faulty, like the ABS sensors which can malfunction when covered in debris or grease. Of course, if the ABS warning light is on, it is important to have your car inspected as soon as possible to prevent non-working brakes.

At least one of the ABS sensors is likely to fail at some point during a vehicles lifetime so its a common repair for mechanics to carry out across all manufacturers. ABS modules, as explained, do not fail that frequently thankfully but faults can occur of course.

The ABS, or anti-lock braking system, on your car is a super important system that prevents your wheels from locking up and therefore simply skidding across the road surface. The system is especially important when braking in adverse weather conditions, i.e. when the road surface is slippery due to leaves, frost or when there are traces of oil on the road. Because of this, keeping your anti-lock braking systems properly maintained is vital.

There's a couple of components in the system that can cause problems. In many cases it will be the ABS sensors that fail, which means the system will not receive the information it requires to activate the system.

You will only know for sure if, and indeed which, ABS sensor requires replacement after a diagnostic investigation has taken place. Therefore we advise in all circumstances that this is carried out prior to booking the replacement of any components.

The cost of an ABS repair depends on your car and what parts your car's manufacturer recommends using for the replacement. Find out what you could save by having your ABS system repaired by Clickmechanic. We can help you with an ABS sensor replacement or ABS ring replacement, just select your car at the top of this page to get a quote.

Cost for an ABS sensor replacement is on average £100, with prices ranging from £65 to £140. Ultimately, the cost depends on your car and what parts your car's manufacturer recommends using for the replacement. Find out what you could save by having your ABS sensor replaced by ClickMechanic by selecting your car below!

Typical symptoms that would point to an issue with the ABS and would require an ABS diagnostic:

• The car's ABS warning light stays on permanently once the engine is started
• The brakes lock up very easily when braking on slippery surfaces
• The brakes do not respond as well as normal under hard braking

A bad ABS wheel speed sensor will often cause the ABS dashboard warning light to come on. Other symptoms may include a loss of traction control, and the vehicle may take longer to stop. It is recommended to get it checked and fixed by a qualified mechanic as soon as possible.

Cost to fix an ABS pump replacement can range between £300 - £1000, depending on the severity of the issue and the parts required.

Yes, many local garages are able to offer collection and delivery for an abs repair on your Austin. With ClickMechanic collection & delivery is free if your vehicle is drivable. Once booked a mechanic will pick up the vehicle on the day and time of your choice, do the work, and return the vehicle at a time convenient to you. Simply enter your vehicle registration number and postcode to get an upfront price for a abs repair on your Austin.

Yes, mobile mechanics can do an abs repair at your home or office on your Austin, provided there is a safe and sufficient space to conduct the repair or replacement. With ClickMechanic, once booked for a date and time of your choice, your booking will be offered to vetted mobile mechanics in your area.